Non-Polluting
RMAK International Limited
16 Djanie Ashie street
East Legon, Accra
DESCRIPTION
HPC®-HT is a two-part hybrid silicone/solvent resin (Part B is flammable) and (Part A is water-based resins) using specific ceramic compound loads for application directly over surface temps of 250°C (482°F) and up to 600°C (1112°F). It was designed to block and hold the interior temperature on the surface and reduce heat transfer loss to ambient.
After Part A and Part B are blended together, HPC®-HT Coating offers a ‘green’, nonflammable, non-toxic formula for high-heat surface applications. HPC®-HT is easily applied, and can be sprayed direct to metal, concrete and other high-temperature surfaces up to 600°C.
FEATURES
CHARACTERISTICS
Product Chemistry | Silicon Based |
Volume Solids | 84% |
VOC Level | 200 g/L, 1.67 lbs./gal. |
Dry Time (at 400-650°F) | 20 minutes per coat |
Cures By | Evaporation on hot surfaces |
TYPICAL USES
1. As the high-temp insulation coat for surfaces greater than 250°C, over hot pipes, tanks, and valves
2. To hold heat on the surface of the pipe, valve, etc.
3. As a system to block conductive and convective heat transfer
4. Applied when a hot system cannot be shut down.
APPLICATION METHODS
CAUTION: Do not expose Part B to open flame as solvent used to allow silicones to blend faster. After Parts A and B are blended, product is non-flammable for use in spraying direct to hot surfaces reaching 650°C
For specific instructions on surface preparation, mixing and application, please refer to the HPC®-HT Coating Application Instruction Sheet. If HPC®-HT is applied over hot exterior surfaces, and can be over-coated, Super Therm®, Rust Grip®, Enamo Grip or HPC system top coat can be used according to what is needed.
HPC®-HT must be completely dry before applying top coat. HPC® Multi-Mesh Membrane System or high-temp mesh can be used on hot pipes when continuous cycles cause movement, and where continuous impact caused by workers handling the hot pipe is unavoidable.
RESOURCES & DOWNLOADS
Rust Grip® is our leading corrosion coating that eliminates 60% of project costs by avoiding the need to grit blast or dispose of hazardous waste (including asbestos).
Super Therm® is our solar heat blocking product that blocks 95% of solar heat load irrespective if the coating is clean or becomes dirty, it physically lacks the density to load and hold heat. Whether it is a building (roof), tanks, piping, containers or portable offices, if Solar Heat is an issue, Super ThermⓇ will stop the heat from loading all together taking a proactive approach to heat load and heat transfer.
Contact our team at Superior Product Coatings Africa to see if you qualify for a demo application of our leading energy saving or corrosion management solutions.
Superior Product Coatings Africa are official distributors of SPI Coatings range of international products, in Southern Africa.
RMAK International Limited
16 Djanie Ashie street
East Legon, Accra
+233 544 919695
+233 204 350250